Air Vents Premium TPU Protection Film for Model Y Juniper 2025+

Premium TPU Air Vent Protection Film for Tesla Model Y Juniper

Protect your Tesla Model Y Juniper interior air vent surfaces with precision-cut transparent TPU film. Designed to follow the original vent contours, this low-profile protective layer helps reduce everyday scratches, scuffs, and surface wear while preserving the factory interior appearance.

Preserve Your Original Interior Finish

Air vent trim is exposed to dust, fingerprints, cleaning cloths, and everyday contact. Over time, these interactions can leave fine scratches and visible wear on the original surface.

This transparent TPU film provides an additional protective layer over the designated vent areas, helping preserve the appearance of your Tesla interior without adding a bulky trim cover.

Vehicle Compatibility

Designed exclusively for:

• Tesla Model Y Juniper 2025+

The film is cut for the refreshed Model Y Juniper interior vent layout. It is not designed for the earlier Model Y 2020–2024 or other Tesla models with different vent shapes.

Advanced Five-Layer TPU Construction

1. Surface Protection Layer
Helps resist minor scratches and everyday surface abrasion.

2. Micro-Nano Coating
Designed to improve surface cleanliness and resistance to environmental contamination.

3. TPU Core Layer
Provides a flexible protective film structure that follows the contours of the covered surface.

4. High-Clarity Adhesive Layer
Helps the film bond to the original surface while maintaining a clear appearance when correctly installed.

5. Protective Base Layer
Covers the adhesive before installation to help keep it clean.

Designed to Preserve Airflow

The ultra-thin, flexible film is designed to cover the specified vent trim surfaces without acting as a physical grille or blocking the air outlet.

Correct alignment is essential. Make sure the film does not extend across the vent openings, movable louvers, or other functional components.

⚠️ Compatibility & Installation Notice

This kit is designed specifically for the Tesla Model Y Juniper 2025+ interior vent layout. Confirm the film shape against your vehicle before removing the adhesive backing.

The film is a surface protector, not a replacement vent cover or a structural component. Do not apply it over movable vent parts or any area that could interfere with airflow.

Self-healing performance applies to minor marks on the film's surface. Deep cuts, punctures, or damage reaching through the film may not recover.

Installation

1. Prepare a Clean Environment
Install in a well-lit, low-dust area away from strong wind to reduce the chance of dust becoming trapped beneath the film.

2. Clean the Vent Surface
Remove dust, fingerprints, oil, and residue from the designated mounting area.

3. Prepare the Application Solution
The supplier recommends mixing approximately three drops of neutral shower gel with water in a spray bottle. Follow the supplied instructions and avoid corrosive or strongly scented cleaning products.

4. Wet the Surface and Film
Apply the recommended solution to the film and target surface as directed by the supplier.

5. Align the Film
Position the pre-cut piece carefully and confirm that its edges follow the vent contours.

6. Remove Liquid and Air Bubbles
Use a suitable squeegee to work gently from the center toward the edges until the film lies flat.

7. Allow the Adhesive to Cure
Follow the supplied instructions. The supplier recommends avoiding car washing and rain exposure for three days after installation.

⚠️ Installation & Care Tips

Do not install the film over a dirty, oily, or wet surface unless the supplied wet-application instructions specifically call for it.

Avoid excessive stretching, sharp tools, and overheating during application. If the film is misaligned, follow the supplier's repositioning instructions rather than forcing the edges into place.

Wait three days before washing the vehicle or exposing the installation area to rain, as recommended by the supplier.

Specifications

FAQ