Paint Protection Film For Tesla Model Y Juniper / Model 3 Highland / Model YL (8 pieces)

Door Corner Paint Protection Film for Tesla Model 3 Highland / Model Y Juniper / Model YL

Help protect your Tesla's painted door corners from everyday scratches, scuffs, and contact marks with precision-cut TPU paint protection film. The transparent finish preserves the original paint appearance, while the flexible film and self-healing topcoat help maintain a clean, low-profile look over time.

Protect the Areas Most Exposed to Daily Contact

Door corners can be scratched by bags, keys, clothing accessories, and accidental contact when entering or exiting the vehicle. These clear TPU protectors provide an additional barrier over the covered paintwork, helping preserve the appearance of your Tesla's exterior.

The transparent finish maintains the original paint color and styling while providing discreet protection in areas that are frequently exposed to minor contact.

Vehicle Compatibility

Select the version designed for your vehicle:

• Tesla Model 3 Highland 2024+
• Tesla Model Y Juniper 2025+
• Tesla Model YL 2026+

Each option uses a model-specific pre-cut pattern. Confirm your vehicle generation before ordering because door corner shapes vary between models.

Flexible TPU with a Self-Healing Topcoat

Thermoplastic polyurethane (TPU) is a flexible protective film material designed to conform to the painted surface of your vehicle. The nano-coated top layer is intended to help resist everyday contamination and recover from some minor surface marks when exposed to suitable warmth.

The self-healing effect applies to light surface marks in the coating, not deep cuts, punctures, or damage that reaches through the film. Actual performance depends on the mark, temperature, and condition of the material.

Transparent Protection for Your Factory Paint

The clear film is designed to preserve the original exterior appearance while helping shield the covered paint from routine scuffs and contact marks.

The repositionable adhesive is intended to make alignment easier during installation. Always follow the supplied instructions and use care when removing or repositioning the film to avoid damaging the film or underlying paint.

⚠️ Compatibility & Installation Notice

This kit is designed for the specific door corner geometry of the selected Tesla model. Do not assume that one version will fit all Model 3 or Model Y generations.

The paint surface must be clean and free from wax, oil, dust, and loose contaminants before installation. Avoid applying the film over damaged, peeling, or poorly repaired paint.

If you are unsure about the fit or installation process, test the alignment carefully and contact the seller before altering the film.

Installation

1. Clean the Door Corners
Thoroughly clean the painted surfaces and remove dust, wax, oil, and other residue. Allow the surface to dry as directed.

2. Identify Each Film Piece
Separate the pre-cut pieces and match them to the corresponding door corner positions.

3. Align the Film
Position each piece over the target area and check the edges before fully applying the adhesive.

4. Apply and Smooth
Apply the film gradually and use a suitable squeegee to push trapped air outward from the center.

5. Check the Edges
Make sure the film follows the painted contour without excessive stretching, wrinkles, or lifted corners.

6. Allow the Adhesive to Set
Follow the supplied instructions and wait 48 hours before washing the vehicle to allow the adhesive to bond.

⚠️ Installation & Care Tips

Install in a warm, clean, low-dust environment for easier positioning and better edge adhesion.

If small bubbles remain near the edges, follow the supplier's instructions and use a suitable squeegee. Avoid excessive stretching or overheating the film.

Wait 48 hours before washing the vehicle. If the film lifts, wrinkles, or develops significant haze, contact the seller for guidance before removing or modifying it.

Specifications

FAQ