Seat Belt Slot Gap Full Coverage Dust Plugs for Model 3/Y (2pcs)

Seat Belt Buckle Slot Dust Plugs for Tesla Model 3 / Model Y – 2PCS

Keep coins, keys, crumbs and other small items from disappearing into the narrow gaps around the front seat belt buckle area. These soft silicone dust plugs are custom-molded for compatible Tesla front seats and press into place without tools or permanent modification.

Close the Hard-to-Clean Seat Belt Gap

Blocks Everyday Debris
Helps prevent coins, keys, crumbs and other small items from dropping into the narrow opening around the seat belt buckle.

Makes Cabin Cleaning Easier
Instead of retrieving debris from a deep seat gap, remove the plug and wipe or rinse it when needed.

Low-Profile Fit
The molded silicone shape is designed to sit around the buckle opening without adding unnecessary bulk to the front seat area.

Silicone Construction

⚠️ Material Claims Are Supplier-Stated

Tesery describes the silicone as eco-friendly, odorless, non-toxic and heat-resistant. The current product page does not publish an independent material certification, exact temperature rating or laboratory test standard.

⚠️ Front Driver & Passenger Seats Only

This 2-piece set is designed for the driver and front passenger seat belt buckle areas only. Tesery explicitly states that it is not compatible with rear-seat buckle locations.

Dedicated Seat Belt Buckle Cutout

Tesery states that the plug is shaped with a dedicated opening around the buckle insertion slot and release button so the original seat belt can continue operating normally.

The dust plug should sit around the buckle area rather than covering or restricting the buckle mechanism.

⚠️ Verify Seat Belt Operation After Installation

After installation, buckle and unbuckle the seat belt several times. Make sure the buckle tongue inserts fully, the release button remains accessible, and the dust plug does not interfere with normal seat belt operation. Remove the plug immediately if any interference occurs.

Vehicle Compatibility

⚠️ Select the Correct Vehicle Version

Seat and buckle-area geometry can differ between Model 3, Model 3 Highland, Model Y and Model Y Juniper. Choose the version intended for your exact vehicle rather than assuming one molded shape fits every generation.

Quick Tool-Free Installation

1. Confirm the Vehicle Version
Make sure the dust plug matches your exact Model 3 or Model Y generation.

2. Clean the Buckle Area
Remove loose dust and debris from around the front seat belt buckle opening.

3. Align the Cutout
Position the silicone plug so the seat belt buckle, insertion slot and release button remain fully accessible.

4. Press Into Place
Push the flexible silicone plug gently into the surrounding gap until it sits flush.

5. Check the Fit
Make sure the plug sits flat and does not lift, twist or press against the buckle mechanism.

6. Test the Seat Belt
Buckle and release the seat belt several times before driving.

No Tools, Adhesive or Permanent Modification

The flexible silicone design simply presses into the compatible front seat buckle gap by hand. No drilling, screws, glue or cutting are required.

Easy Cleaning & Maintenance

Routine Cleaning
Wipe loose dust and light dirt with a damp microfiber cloth.

Deeper Cleaning
Remove the plug and rinse it with mild soap and water when needed.

Dry Before Reinstalling
Allow the silicone to dry before pressing it back around the buckle opening.

Designed for Hot Cabin Conditions

Tesery describes the silicone as heat-resistant and intended for automotive cabin temperatures. No exact maximum operating-temperature specification is published on the current page.

Specifications

⚠️ Exact Dimensions & Temperature Rating Are Not Published

The current product page does not publish the dust plug dimensions, silicone hardness, thickness, weight or a numerical maximum temperature rating. Do not add those specifications unless they are separately confirmed for this exact product.

Package Includes

2 × Seat Belt Buckle Slot Dust Plugs

Quick Answers